Quantum DXi V1000 - Page 73

Quantum DXi-Series Command Line Interface (CLI) Guide
6-67081-05 Rev B
April 2012
Utility CLI Commands 65
Editing an SNMP Community
syscli --edit snmpcom --name <community_name> [--ipaddress
<community_IP_address>] [--netmask <community_net_mask>]
[--accesstype {get | getset}] [--disable]
This CLI command allows the admin user to edit an SNMP community.
Deleting an SNMP Community
syscli --del snmpcom --name <community_name>
This CLI command allows the admin user to delete an SNMP community.
Deleting All SNMP Communities
syscli --deleteall snmpcom [--sure]
This CLI command allows the admin user to deleted all SNMP communities. If
the --sure option is specified, no confirmation prompt will be displayed.
Sending a Test Trap
syscli --test snmptrap (--trapip <trap_destination>)
This CLI command allows the admin user to send test traps to one or more
destinations.
Utility CLI Commands
The following utilities CLI commands are available:
• Upgrading the System Firmware
• Getting the Cluster Status of Local Node
• Starting Space Reclamation
• Stopping Space Reclamation
• Specifying the Space Reclamation Schedule
• Displaying the Current Reclamation Schedule
• Displaying the Current Reclamation Status
• Node Management
• Displaying Licenses
• Adding a License
• Diagnostic Logs
• Authenticate User (Login Command)
• Release Credential (Logout Command)