1 of 1
ATA
Jumper Settings
DS
CS
PK
Rsvd
S
tand Alone ON
OFF
X
OFF
M
aster with Slave Present ON
OFF
X
OFF
S
lave to Master OFF
OFF
X
OFF
X = PK is a Parking position. The presence or absence of this jumper has no effect on the drive.
Labeling may indicate to place this jumper when configuring as a slave. This is to provide for
retention of the jumper in the event it is needed later.
Jumper Locations
The Fireball SE disk drive has only one location where user configurable jumpers are found. The
jumper block is incorporated into the IDE / ATA cable connector. Using the jumper pins you can
establish the drive Master/Slave configuration.
Fireball SE
Jumper Settings
To Next Page
Need help?
General