EasyManua.ls Logo

Quantum J4E - Page 20

Quantum J4E
28 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
20
How to Clean/Disinfect Equipment:
Hard/Soft Surfaces (Plastic shrouds, metal framing, seat
fabric, tires, armrests and footplate mats, as applicable)
For hard/soft surfaces, remove visible contamination if
present.
{ For plastic and metal use Lysol®/Clorox®
disinfecting spray/wipes and other qualied SARS-
CoV-2 disinfecting products.
{ For other vinyl surfaces, clean with vinyl safe
disinfecting wipes or solutions
Suggested Disinfectants
Birex® SE Disinfectant, Bleach-Rite®
Disinfecting Spray, Citrace® Germicide
Dispatch® Spray Hospital Cleaner
Disinfectant with Bleach
Diluted Bleach Solution (10% dilution or
less); Note: Bleach with pH factor between
7 and 9 is suitable; a product with a pH of
10.5 or higher may damage the vinyl surface
integrity over an extended period of time.
Disinfecting Wipes
Clorox, Green Works, PDI Sani-Cloth HB
Wipes, Lysol, Oxivir, Virox, and CaviWipes.
{ For Tire cleaning, clean with o󰀨 the shelf tire /wheel
cleaners
Electronics (Joystick controller, enhanced displays, touch
screens, remote controls, keyboards, cell phones and
tablets, as applicable)
For electronics, remove visible contamination if present
{ Turn o󰀨 device and disconnect batteries.
{ Never spray any liquids directly into the product(s).
{ Moisten a microber cloth with a mixture of 70%
isopropyl alcohol / 30% water solution. The cloth
should be damp, but not dripping or excessively
wet. Dry surfaces thoroughly to avoid pooling of
liquids and prior to boxing.
Follow all safety instructions for the proper use of the
disinfectant and/or cleaning agent before applying it
to your product. Failure to comply may result in skin
irritation or premature deterioration of upholstery and/
or power chair nishes.
Never use any cleaning or disinfecting agent, solvent,
lubricant, or any other product on the brake pads,
brake discs, transaxle, motor/gearbox of your mobility
product. Doing so may damage the components and/
or cause them not to function properly. Property injury
and/or personal injury may result.
Never hose o󰀨 your power chair or place it in direct
contact with water. Your power chair has a painted, ABS
plastic body shroud that allows it to be easily wiped
clean with a damp cloth.
Never use any chemicals to clean a vinyl seat, as they
may cause the seat to become slippery or dry out and
crack. Use soapy water and dry the seat thoroughly.
WARNING!
Cleaning and Disinfection
Precautions must be taken when cleaning medical
equipment/devices to lower the risk of spreading infection.
This is to limit the spread of illness and other potentially
infection material (OPIM) (blood components).
Use a damp cloth and mild, non-abrasive cleanser to
clean the plastic and metal parts of your power chair.
Avoid using products that may scratch the surface of
your power chair.
If necessary, clean your product with an approved
disinfectant. Make sure the disinfectant is safe for use
on your product before application.
Figure 12. Cleaning and Disinfection
CARE AND MAINTENANCE

Related product manuals