Chapter 3 Operation
Models QT-740 & QT-750 - Operator’s Manual
13
OVERVIEW
To provide precise patient positioning, Model QT-740 and QT-750 radiographic
tables feature a tabletop that "floats" in four directions; transversely (forward and
backward) and longitudinally (left and right). Model QT-750 has the additional
capability of tabletop elevation (i.e., the tabletop can be raised and lowered to
facilitate patient transfer on and off the table).
TABLE CONTROLS
WARNING! All movable assemblies and parts of
this equipment must be operated with reasonable
care. Manufacturer’s equipment recommenda-
tions described in this manual must be observed.
WARNING! To avoid damage to the table, any
load on table top should be distributed as evenly
as possible over the support surface. Do not seat
patient at extreme ends of tabletop when table-
top is not centered. Patients weighing more than
approximately 300 lbs. (136 kg) should only be
transferred on or off the table from front side - in
the center.
WARNING! Do not allow patient to place his/her
hands along the side or below the table rail.
Injury to the patient’s hands and/or fingers is
possible.
Figure 2. Areas Indicated to Keep Hands/Fingers Away From
To Next Page
Loading...
Need help?
General
