Quantum QTM-8000 - When You Are Finished Vacuuming

To Next Page

To Previous Page

21 | Page Rev. 1

To park/lock the Power Nozzle back into the upright position,

place your foot on top of the power head. Next, grasp the wand

assembly and push forward until wand system is fully engaged

in locking tabs.

WHEN YOU ARE FINSHED VACUUMING

Note: ALWAYS EMPTY & CLEAN THE WATER BASIN

Immediately after using the Quantum, remove the water basin

and dump out the dirty water through the top opening or the

air intake cavity. Always empty after each use as shown.

Heavier particles will settle to the bottom of the basin as water

is poured. Once water is poured out, dispose of the bulkier

debris. Clean the water basin with soap and water. Rinse and

dry thoroughly.