QUANTUM SCALAR I6000 & SAFENET KEYSECURE QUICK START GUIDE 24
Step 9: Configure Library Access to the SafeNet KeySecure
To configure the library access to the SafeNet KeySecure:
1 From the menu bar, click Setup > Encryption > Server Configuration.
The EKM Server Configuration dialog box appears.
2 From the Key Server Type drop-down list, select KMIP Key Manager.
3 Fill in the rest of the fields as follows:
For the server IP address, you can enter the following:
- IPv4 address
- IPv6 address—if IPv6 is configured
- Domain name—if DNS is configured
Note: Assign your SafeNet KeySecures on this screen in the order in which you want failover to
occur. Server 1 is the primary server; Server 2 is the secondary server; and so on. For an initial key
request, the library tries Server 1 (the primary server) first. If Server 1 is not available to perform a key
request, the library tries Server 2. If server 2 is not available, the library will try Server 3, and so on, in
order, until it finds a server that can perform the request. Once found, this server remains the active
server until it fails a key request or the library is rebooted. At that point, the library starts over and uses
Server 1 for key requests. If Server 1 is not available, it will try Server 2, and so on.
To Next Page
Loading...
