16
For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : consumerproducts@panasonic.com
Camera Recording
Before you begin...
• Connect Camcorder to power source.
• Insert cassette with record tab (page 10).
View recording scene on EVF (Electronic
Viewer Finder).
1 Set POWER to
CAMERA.
• Be sure POWER
is fully turned to
CAMERA position.
• EVF turns on/off
by the POWER switch.
2 Look into EVF and adjust VISION
ADJUSTMENT to your eyesight.
3 Hold down TAPE SPEED for about 1
second to change tape speed to SP/SLP
(page 10).
4 Press RECORD/
PAUSE to start or
pause recording.
5 Set POWER to
OFF when finished.
• To remove the cassette, slide the
TAPE
EJECT switch (page 10).
VISION
ADJUSTMENT
2
EVF Indication
(Record/Pause mode)
EVF Indication
(Record mode)
Tape speed
Note:
• When Camcorder is aimed at excessively
bright objects, or bright lights, a vertical bar
may appear in the picture. This is normal for
the CCD pick-up. Try to avoid this when
possible.
Recording via EVF
3
Built-in
Microphone
1, 5
4
03.VM-D52 Basic p16-18 02.1.28, 9:56 AM16
To Next Page
Loading...
