Quectel EC25 Mini PCIe - WAKE# Signal

LTE Standard Module Series
EC25 Mini PCIe Hardware Design
EC25_Mini_PCIe_Hardware_Design 35 / 79
Table 15: Indications of Network Status (AT+QCFG="ledmode",0, Default Setting)
Table 16: Indications of Network Status (AT+QCFG="ledmode",2)
3.10.6. WAKE# Signal
The WAKE# signal is an open collector signal which is similar to RI signal, but a host pull-up resistor and
AT+QCFG="risignaltype","physical" command are required. When a URC returns, a 120ms low level
pulse will be outputted. The state of WAKE# signal is shown as below.
URC return
120ms
High
Low
(external
pull-up)
Figure 14: WAKE# Behavior
Pin Status
Description
Flicker slowly (200ms Low/1800ms High)
Network searching
Flicker slowly (1800ms Low/200ms High)
Idle
Flicker quickly (125ms Low/125ms High)
Data transfer is ongoing
Always Low
Voice calling
Pin Status
Description
Low Level (Light ON)
Registered on network successfully
High Impedance (Light OFF)
 No network coverage or not registered
 W_DISABLE# signal is at low level. (Disable RF)
 AT+CFUN=0, AT+CFUN=4