30
Commissioning
1. Remove the cup warmer (j).
2. Fill the tank (n), under the cup warmer, with drinking water, softened if
possible.
3. Connect the machine to an electric socket, switch on the machine with the
general switch (k) in position 1.
4. The machine starts to fill the boiler.
5. Activate the coffee brew group lifting the lever (b): deliver water from the
group to ensure that the circuit has filled correctly.
6. Wait until the machine reaches the working temperature indicated by the
red light that switches off (l) and the boiler gauge pointer (h) that is
to indicate a value between 1 Bar and 1,5 Bar.
When used for the first time, with the machine warmed, allow an
outlow of approx.0,5 litres of water to flush the delivery group
activating the coffee delivery.
Coffee brew
1. Remove the filter holder (c) from its seat, turning it clockwise.
2. Fill the filter with one or two doses of coffee (according to the filter
inserted).
3. Press the coffee with the presser.
4. Place the filter holder (c) to its seat, turning it anti-clockwise.
5. Place the cups under the corresponding outlets under the filter holder.
6. Lift the coffee delivery lever (b) to the horizontal position to start the coffee
brew, and after a few seconds the coffee brew starts.
When the desired amount of coffee has been delivered, lower the group
lever to the vertical position.
To Next Page
Loading...
Need help?
General
