31
Steam delivery
1. Wait until the heating light switches off (l) and make sure that the
pressure indicated on the boiler gauge is over 0.8 Bar.
2. Open the steam valve (d) for a few seconds and discharge a little steam
into the drip tray (i) then immerse the steam wand (e) in the liquid to be
heated and open the tap, when the required temperature is reached, close
the tap.
After heating the beverage, always discharge a little steam from
the wand to clean the spray holes.
For this model, without adjustment PID, the machine temperature
management is by means of a specific pressure switch.
Hot water delivery
1. Place the container to collect the water under the hot water wand (g).
2. Open the water tap (f) to deliver the hot water.
3. When the required level is reached close the water tap.
To Next Page
Loading...
Need help?
General
