P/N:20760050033-A
~ 12 ~
3.3 空调器安装 Air Conditioner Installation
安装步骤：
1. 在安装面上画出柜门开孔示意图，将阴影部分切割掉。不同型号空调的柜门开孔示意图请
参考相应规格书；
2. 根据安装示意图中示意的方向，将空调安装在机柜上；
3. 如果需要安装水管，请将水管安装在底部接水管处。
Installation steps:
1. Draw on the cabinet mounting cut-out map according to Figure, cut off the shadow part.
Different models of air conditioner cabinet mounting cut-out maps refer to its specification.
2. According to the direction of the schematic of installation, installed the air conditioner on the
cabinet.
3. Please to install drain pipe on drain hole if you need.
安装完成后的确认检验项：
1. 请勿在高油污、易燃气体、高腐蚀性及环境温度超过 55℃、湿度超过 95%的环境下使用该产
品；
2. 确保产品安装后倾斜度不大于 3°；
3. 确保控制柜密封良好以免漏入空气产生不必要的冷量损失和产生过多的冷凝水；
4. 产品安装结束后，确保产品直立 30 分钟后再加电运行。
Double check lists after Installation:
1. Don’t apply this unit in high oil, burning gas, explosive gas, strong corrosively condition, the
ambient air must be under 55℃, and the humidity not higher than 95%;
2. Make sure that the lean of the product no more than 3°;
3. Make sure that the cabinet should be sealed well to avoid the cooling losing and avoid
ambient moisture penetrate into cabinet, this will avoid produce more condensate water;
4. Ensure that the product is up and running in upright 30 minutes.
3.4 电气布线 Electrical Wiring
空调器在使用前需根据本手册的说明进行电气连接，建议客户优先使用附件中的线缆。客户可
以自备线缆，如果客户不能确定所选电缆规格是否合适，可联系酷克售后服务部门。
Does Electrical Wiring according to the manual before use the air conditioner; we suggested
To Next Page
Loading...