Quick AC Series - 其他故障分析与处理 Other Fault Analysis and Processing

P/N:20760050033-A
~ 20 ~
4.5 其他故障分析与处理 Other fault analysis and processing
故障状态
Fault state
原因分析
Analysis of the reasons
故障排除方法
Solutions
电源接通后，柜内温
度过高，但空调不运
转。
Power on the
switch, the cabinet
temperature is too
high but the air
conditioner is not
working.
1、停电或无电源。
Power failure or no power.
2、设定温度高于柜内温度。
The cooling set temperature is higher
than the cabinet temperature.
3、系统故障。
System fault.
1、检查电源、电路。
Check the power supply and the
electric circuit.
2、根据需要设定压缩机启动温度。
Setting cooling temperature
according to the needs.
3、请与专业维修人员联系。
Please contact professional
maintenance.
设备正常运转，但制
冷效果不理想
The air
conditioner is
running but the
cooling effect is not
good.
1、该机型制冷能力与负荷不匹配。
The cooling capacity of the air conditioner
is not match with the load.
2、环境温度过高。
The ambience temperature is too high.
3、其他系统故障。
Other system fault.
1、 根据负荷大小重新选配或增配制
冷设备。
To add or choose another air
conditioner according to the load.
2、 请确保机器工作环境温度在正常
使用范围内。
Ensure the machine is used in
the correct range.
3、 请与专业维修人员联系。
Please contact professional
maintenance.
正常运转中。突然停
止制冷，且电器系统
无故障。
The machine is
stopping suddenly,
and the electric
system is normal.
1、 柜内温度已达到设定温度。
The cabinet temperature greater than or
equal to the cooling set temperature.
2、 其他系统故障。
Other system fault.
1、 根据需要设定压缩机启动温度。
Setting cooling temperature
according to the needs.
2、 请与专业维修人员联系。
Please contact professional
maintenance.