P/N:20760050033-A
~ 15 ~
If the return air temperature is greater than or equal to the default set point of compressor start
temperature (35℃), the air conditioner enters the cooling mode. The external fan is running, the
monitor display symbol. The compressor is running after external fan 60 seconds, the
symbol is bright. If the compressor is running, the minimum running time is less than the set time
(default time is 5 minutes).
If the return air temperature is less than or equal to the default set point of compressor start
temperature (35℃) subtracts compressor stop hysteresis temperature (5℃), and the compressor
running time is more than or equal to the minimum set time(the default time is 5 minutes),then the
compressor stopped. The symbol is extinguished. The external fan stopped after a while, and
the symbol extinguished.
加热模式
若回风温度≤加热器设置温度（默认 0℃）-加热器运行回差温度（默认 5℃），则加热器开启，
对系统进行加热，此时 亮。
若回风温度≥加热器设置温度（默认 0℃）+加热器运行回差温度（默认 5℃），则加热停止，
熄灭。
注：加热功能只适用于带加热器机型。
Heating mode
If return air temperature is less than or equal to heater start temperature (0℃) subtracts
heater stop hysteresis temperature (5℃), the heater runs to heat the system and the symbol
bright.
If the return air temperature is greater than or equal to heater start temperature (0℃) plus
heater stop hysteresis temperature (5℃), the heater is stopped and the symbol extinguished.
Attention: The heating function is only applicable to models with heater.
4.3 手操器使用说明 Instructions of Display Panel
在正常情况下，手操器显示柜内温度，告警时显示告警代码；
手操器底部为状态栏，不同的指示灯代表不同状态；
通过手操器可查看空调器各项参数及对各参数进行设置（用户参数）。
The display panel shows cabinet temperature under normal circumstance, and shows alarm
code when there is a malfunction.
In the bottom is the status bar, different lamp represents different status.
You can check and set various parameters of air conditioner by the display panel (User
Parameters).
To Next Page
Loading...