P/N:20760050033-A
~ 17 ~
press again or press”M”, the monitor will return the main interface.
The Condenser temperature query:
Under the return air temperature interface, press“”once will show condenser temperature,
press again or press”M”, the monitor will return the main interface.
Attention: Air conditioner has been setting parameters, the default parameters refer to table 5-2；
Part of the parameters need to password, please contact our customer service.
参数设置：
长按“M”键 5 秒，进入参数设置状态，显示参数代码，用“”键选择参数代码，选择一个代码
后按“Set”键则显示该代码对应的参数值，这时再用“”键即可对参数值进行设置，设置完成后再
按“Set”键，回到显示参数代码状态。在显示参数时按“M”键可退出参数设置状态，在设置参数值的过
程中按“M”键表示放弃，退出但不改变参数值。
Parameter setting:
Long press "M" key for 5 seconds, enter the parameter setting mode, then display the code of
parameters, with "" key to select the code of parameters, select a code and press "Set" button
will display corresponding parameter values of the code, then re-use "" button can set the
parameters, after finished the setting, press "Set "button, back to display states. During the setting
mode, Press "M" key to exit the parameter setting mode, in the process of the parameter values
setting by pressing "M" button that give up, quit, but does not change the parameter value.
表 4-2 设置代码
Table 4-2 Setting Code
压缩机启动温度
Compressor start temperature
压缩机停止回差温度
Compressor stop hysteresis
temperature
加热器启动温度
Heater start temperature
该功能仅适用于含
加热器机型。
This function is
only applicable to
the models with
heater.
加热器停止回差温度
Heater stop hysteresis temperature
高温告警温度
High temperature alarm
To Next Page
Loading...