Quick BTR185 Series - Mechanical System Checks; Control Cable Routing

EN
BTR185 INSTALLATION AND USE MANUAL - REV009A
34
BTR1854 - Installation
• Ensure that the system is free to open and close
without any mechanical hindrance.
4.4 - Mechanical system check and adjustmen
4.5 - Installation of the cable in the lid
Fig. 15
• The BTR propeller should be disconnected from power.
• Take the ring off and remove the pin (part. A).
• unhook the actuator from the lever (part B), ensuring that the system is free to
open and close without any mechanical hindrance.
WARNING: when the actuator is manually unhooked, the thruster com-
pletely comes out due to its weight, therefore ensure that nobody stands
in its range of action.
g. 15
A
B
Follow the sequence described below to verify the opening of the hatch:
Fig.16
• Thread one end of the cable through the lid’s bracket (part. A).
• Pass the cable beneath the xed guide of the tunnel (part. B).
• Hook the end of the cable to the two springs (that are already mounted onto the moving body) (part. C).
• Final installation of the cable in the lid (part. D).
g. 16
D
GUIDE
STEEL CABLE
TUNNEL
SPRINGS
LID’S BRACKET
STEEL CABLE
A
B
C