19
EN
TCD1022 E / 1042 E - REV005A
REMOTE CONTROL ENABLING
To enable the remote control, press the enabling button and keep it pressed for at least 1 second.
After this period the enablement LEDs will start flashing with greater frequency and the control will emit a short sound.
Release the enablement button, the enablement LEDs will remain steadily lit on and the remote control will be enabled. In this
condition the control will emit a short sound every 5 seconds.
THRUSTER ACTIVATION
Bow thruster activation
WARNING: once the direction button (TCD 1022) or the joystick (TCD 1042) has been released, the boat will continue to
move according to the inertia of the movement.
When the propeller is activated the direction led corresponding to the imparted movement (red to the left, green to the right) will
light on and the control will emit an intermittent sound.
• To move the bow to the right, keep the right direction
button (TCD 1022) pressed down, or move the joystick (TCD
1042) to the right at the end of its stroke.
• To move the bow to the left, keep the left direction but
-
ton (TCD 1022) pressed down, or move the joystick (TCD
1042) to the left at the end of its stroke.
OPERATING
STERN THRUSTER ACTIVATION
Because of the space limits of the bow, some boats only have a stern thruster.
In this case, this thruster will be used in the same way as that for the bow thruster.
(see
Bow thruster activation
paragraph).
To Next Page
Loading...
Need help?
General
