Quickie Pulse 6 BC User Manual

119832 Rev. B
16
ENGLISH
VIII. SET-UP, ADJUSTMENT & USE
VIII. SET-UP, ADJUSTMENT & USE
NOTES:
1. Work Surface For Set-Up:
Use a flat surface, such as a table, to assemble, adjust and check your chair. This makes the
steps easier and helps ensure a correct set-up.
2. Fasteners:
• Many of the screws and bolts on this chair are special high-strength fasteners and may
have special coatings.
• Many nuts are of the Nylock type. They have a plastic insert to help prevent loosening.
WARNING
1. Use of improper fasteners may cause the chair to fail.
2. Over- or under-tightened fasteners may fail or cause damage to chair parts.
3. If bolts or screws become loose, tighten them as soon as you can. Loose bolts or
screws can cause damage to other chair parts causing them to fail.
3. Washers & Spacers:
• Note the position of washers and spacers before disassembly.
• To avoid damage to the frame, replace all washers and spacers when you reassemble
parts.
4. Torque Settings:
• A torque setting is the optimal tightening for a particular fastener. Use a torque
wrench that measures 120 inch-pounds to secure screws, nuts and bolts on this chair.
NOTE–
Unless otherwise noted, use a torque setting of 120 inch-pounds for all fasteners.
TOOLS YOU WILL NEED
1. Basic Tool Kit:
To set-up, adjust and maintain your chair you will need the following tools:
2. Torque Wrench:
If you plan to adjust and maintain this chair yourself, Sunrise recommends that you use a
torque wrench.
NOTE–
The wrench must measure inch-pounds. You can buy a torque wrench and proper sockets
from a hardware store.
CHECK-OUT
Be sure this chair performs to your chosen operational settings. If it does not, turn the chair
off immediately and have your supplier reprogram your wheelchair as needed.
NOTE–
Repeat this procedure until the chair performs to your specifications.
WARNING
When properly set up, this chair will operate smoothly. Check to see that all compo-
nents work properly. If you detect a problem, be sure to correct it before use.
• 5mm Allen Wrench
• 6mm Allen Wrench
• 8mm Allen Wrench
• 3/8" combination wrench
• 10mm combination wrench
• 13mm combination wrench
• 18mm combination wrench
• 17mm deep socket wrench
• 19mm socket wrench
• Phillips screwdriver #2
• Flat-head screwdriver
• Wire cutters
• Needle nose pliers

Quickie Pulse 6 BC Specifications

General

Brand	Quickie
Model	Pulse 6 BC
Category	Wheelchair
Language	English