Quickie Salsa User Manual

SALSA/SALSA M 35
Rev.5.0
6.9 Standard Seat height adjustment
WARNING!
Make sure the top frame does not trap your fingers. Get
someone to hold the seat steady during adjustment.
To change the seat height:
Salsa Rear Wheel Drive only:
Remove the two bolts from the front seat posts, using a •
5mm allen key.
Access the bolts by removing the front cover.•
Take the safety clips off the flat rear posts, pull the ring •
pins out and loosen the two clamping bolts.
Lift/lower the seat height by choosing the required hole •
position on the rear seat posts.
Replace the pins, clips and bolts. Tighten the bolts.•
Choose the matching set of holes for the front seat posts. •
Replace and tighten the bolts, (Fig.6.9 - 6.11).
Salsa Mid-Wheel Drive only:
Undo the 2 hand-wheels at the front, pull the release pin •
& tilt the seat back.
Remove the 2 socket studs from the back seat posts. •
Lift/lower the seat to the required position.•
Align the holes then refit & tighten the socket studs.•
Remove the 2 socket studs from the front seat posts. •
Lift/lower the posts to match the required position.•
Align the holes then refit & tighten the socket studs.•
Close the seat, refit & tighten the hand wheels •
(f ig.6.10.1).
Fig. 6.9
6.8 Rehab seat depth
Loosen the arm rest width adjustment screws, using a
13.0mm spanner, (2 and 3, Fig 6.7).
Loosen the Mechani• cal Fixed Recline/ Gas Strut /
electric Actuator fixing screws, (1 and 2, Fig 6.8).
Repeat for the other side.•
Slide the inner seat frame to the desired position.•
Tighten all screws, (Fig.6.7-6.8).•
WARNING!
Sunrise Medical strongly recommend that you •
contact your approved Sunrise medical servicing
agent to carry out this task.
Fig.6.7
1
2
3
4
Fig. 6.8
Fig. 6.10
Fig. 6.10.1

Quickie Salsa Specifications

General

Brand	Quickie
Model	Salsa
Category	Wheelchair
Language	English