QuickJack™ Portable Car Jack 14 P/N 5900959 — Rev. L1 — December 2020
Setup Checklist
Following are the steps needed to install a QuickJack. Perform them in the order shown.
☐ 1. Review the setup Safety Rules.
☐ 2. Make sure you have the necessary Tools.
☐ 3. Select the setup Site.
☐ 4. Unpack the Components that came with the QuickJack.
☐ 5. Make sure there is adequate Clearance on all sides and above.
☐ 6. Locate the QuickJack Box 3.
☐ 7. Locate and examine the Air and Hydraulic Cylinders.
☐ 8. Install the Hydraulic Elbow Fittings.
☐ 9. Prepare the Short Hydraulic Hoses.
☐ 10. Understand Quick-Connect Fittings
☐ 11. Route the Short Hydraulic Hoses.
☐ 12. Prepare and connect the Long Hydraulic Hoses.
☐ 13. Pressurize the Air Cylinders.
☐ 14. Find a location for the Power Unit.
☐ 15. Install fittings on the Power Unit.
☐ 16. Connect the Power Unit to a Power Source.
☐ 17. Fill the Hydraulic Fluid Reservoir.
☐ 18. Check the Breather Valve.
☐ 19. Connect the Hydraulic Hoses.
☐ 20. Bleed the Hydraulic Cylinders.
☐ 21. Review the Final Checklist.
☐ 22. Test the QuickJack.
☐ 23. Leave the Manual for the owner/operator.
To Next Page
Loading...
