Quicksilver 505 Cabin - Interior Cabin Filler (Optional); Back Bench Filler Seat (Optional)

23
Quicksilver 505CAB — System & Component Overview and Operaon
Cockpit Table
Table base
Table leg
Cockpit table
Interior Cabin Filler
Filler boards
Filler cushion
11. Interior Cabin Filler (oponal)
An oponal interior cabin ller is available for this boat, allowing you to convert the forward V-berth
area into a full size maress for sleeping. Simply place the ller boards in the grooved edge along the
V-berth. The boards will lock into place due to their shape. Compete the berth by placing the ller
cushions over the ller board.
12. Back Bench Filler Seat (oponal)
An oponal back bench ller seat is available to increase the seang area in the cockpit by creang a
connuous back bench at the a end of the boat. When installed, the back bench ller covers the
motorwell, however, it does not interfere with normal operaon and trimming of the engine. If you
want to trim the engine to trailer posion or use the boarding ladder, the seat will rotate forward.
Simply pull the upper bar on the seat frame forward and the seat will move out of the way.
Before trimming the engine to trailer mode, make sure that
the back bench ller is rotated forward. Failure to do so
could cause damage to the engine and bench seat.