QuietCool Portable Evaporative Cooler
1.0 Introduction
Your QuietCool was engineered to be the most efficient portable evaporative cooler manufactured. It was
manufactured and assembled at our plant in Houston, Texas.
Your QuietCool was tested 3 ways. Your unit was tested for 1. Maximum air flow at operating static pressure.
Only QuietCool is tested in operating conditions with 2. Water and 3. Electricity before it is shipped.
QuietCool is easy to operate – needs only tap water and electricity to operate.
QuietCool is easy to move – roll your QuietCool to the area you
want to cool. QuietCool comes standard with straight and swivel
/ lock casters which make moving your QuietCool a breeze.
1.1 Quick Start – Your Quick Start Information is located inside the
information packet shipped with your unit.
Look on the front of your QuietCool in a plastic sleeve.
1.2 Evap-O-Matic – Chemical Water Treatment. Operate your unit 2
weeks – flush out old water – add clean water – then add Chemical Water
Treatment tablet. Note; Tablet makes water foam which can cause unit to
spit droplets of water temporarily. Foam subsides in 1 – 2 working days.
2.0 How Evaporative Cooling Works
Keeping in mind that regular fans only circulate same temperature air -
same humidity – your QuietCool portable evaporative cooler takes that same existing air, combines it with evaporating
water (which dramatically lowers the temperature) immediately relieving hot, dry areas, similar to the conditions when a
natural rain storm approaches, the temperature drops noticeably cooler, because the air is saturated with water. Because your
air is now saturated with water it becomes noticeably cooler. In high humidity areas the temperature will not be as cool –
however, the QuietCool was engineered efficient to evaporate perspiration and sweat from employees to keep them cooler.
3.0 Unpacking your new QuietCool unit
Note: Carefully examine your QuietCool shipping carton for damage before
opening. If your carton is damaged – notify the shipper immediately!
Your QC36” unit was shipped on a wooden skid covered with a cardboard cover
and lid – strapped. First remove the straps then you may lift the whole cardboard
box off the unit and skid. Your QuietCool must now be lifted off the wooden skid.
4.0 Set-up your QuietCool unit.
Roll your QuietCool unit to a level surface and lock the swivel casters to prevent
accidental movement.
Electrical cord for 120V, 20Amp connection.
Note: Standard ¾” water connection for
utility water source under 60 p.s.i.
To Next Page
Loading...
Need help?
General
