Section VII - Compressor Fluids
Quincy Compressor-QSI
®
99
Converting to QuinSyn PG
Normal Machines
Flush clean machines presently using QuinSyn or Quin-
Drain compressor thoroughly while hot, including all the
Flush and run compressor until it reaches normal operat-
Drain all the QuinSyn Flush and discard in accordance
-
NOTICE!
If all the previous uid is not removed from the
compressor, excessive foam may be visible in the
uid level sightglass. If this occurs, repeat the
ushing procedure.
Varnished Machines
Flush varnished machines presently using QuinSyn or
Drain compressor thoroughly while hot, including all the
-
send to Quincy Compressor Fluid Analysis to determine
-
Drain or continue to run compressor as advised by the
NOTICE!
More than one ush may be required to remove
varnish build-up and reduce the TAN to an ac-
ceptable level. It may be necessary to change the
uid lter more frequently while the machine is
being cleaned.
run compressor until it reaches normal operating tempera-
the original charge of the QuinSyn Flush and discard in
accordance with all local, state and federal disposal regu-
-
If advised to drain the QuinSyn Flush, run compressor
discard in accordance with all local, state and federal
To Next Page
Loading...
Need help?
General
