Section VII - Compressor Fluids
102 Quincy Compressor-QSI
®
Quincy
Compressor Fluid Analysis
2300 James Savage Road
Midland, Michigan 48642-6535
UNDENIABLY THE WORLD’S FINEST COMPRESSORS
Sampling Procedures
Preferred sample location is the fluid filter. If unable to take sample from fluid filter, proceed as follows:
1. Shutdown and lockout compressor.
2. Relieve pressure in reservoir.
3. Remove plug from reservoir drain line.
4. Drain water from reservoir and discard in approved manner.
5. Fill sample bottle with fluid.
6. Close valve and replace plug in drain line.
7. Return compressor to service and check fluid level during operation. Service with fluid as required.
Using fluid filter sample valve, proceed as follows:
1. Open valve, drain 2-4 ounces of fluid from filter and discard in an approved manner.
2. Fill sample bottle.
3. Close valve.
After collecting sample from either of the above methods:
1. Fill out information label completely.
Be certain to provide all information as to possible hazards related to a given sample. If this situation exists, all
information shall be clearly marked on the sample bottle label.
2. Attach Sample Bottle Label to the bottle and put bottle in mailer.
3. Place Shipping Label on the outside of the mailer and send it by UPS.
FROM: ___________________________________ FROM:
Customer Fax # ___________________________
Model No. ___________ Serial No.
Fluid _______________ Sample Date _________ TO: Quincy Compressor Fluid
Analysis
Hours on Fluid _______ Hours on Machine ____ 2300 James Savage Road
Distributor ________________________________ Midland, MI 48642-6535
Sample From Reservoir Filter
Sample Bottle Label Shipping Label
Note: A fluid sample valve kit is available from Quincy Compressor. Contact the Service Depart-
ment and ask for part number 143286.
To Next Page
Loading...
Need help?
General
