Quooker Combi+ - Disconnecting the Tank; Switching off; Draining; Isolating

2
4
1
3
1. Switching o
Press the on/o switch at the top of the
tank to switch it o. Do not unplug the tank
from the socket yet.
2. Draining
Open the boiling-water handle of the tap
and leave the water running until it is cold.
Then close the tap again. Note: At rst, the
water is very hot.
3. Isolating
Close the main shut-o valve or the stop
valve on the inlet combination (small
grey knob). Check that the Quooker is
depressurized by opening the Nordic
single tap or the boiling-water handle
of the Fusion or Flex tap again. If it is
depressurized, no water should ow out
of it.
4. Disconnecting
Unplug the tank from the socket and the
LED cable from the back of the tank cover.
Disconnect the tap and inlet hoses and
remove the tank. Drain the tank into the
sink via the hoses.
Disconnecting tank
• In case of service.
F
On/off