8 Unscrew the cap screws with the supplied allen key and lift the cover. Push the hose connector
through the hole in the cover and gently disconnect the three wire plugs.
9 Remove the insulation. Start with the centre piece.
10 Use the pipe wrench to unscrew the eight nuts anti-clockwise and remove the internals.
Please note: There is still water left in the tank.
11 Remove the filter by pulling the metal clips apart. Empty the tank and discard any loose scale.
Use the supplied Scotchbrite with water to lightly remove the bulk of the scale from the tank,
internals and filter.
8
10
9
11
Please note
Do not use any descaling agents or
abbrasive pads when removing scale from
the tank.
click!
To Next Page
Loading...
Need help?
General
