Quooker Scale Control Plus - Installing the Scale Control R with PRO3 B

Installation of the Scale Control R with a PRO3 B
– Follow the steps below to install the Scale Control R with a Quooker PRO3 B tank.
– The ‘Q’ on the hood of the tank is the on / off switch.
B
1
3
21
1. Connecting the inlet hose
Connect the reducing coupler from the
Scale Control R to the inlet reducing
valve with the blue bre washer. Connect
the Scale Control R inlet hose (long) to
the reducing coupler.
2. Connecting the outlet hose
Connect the Scale Control R outlet hose
(short) to the tank inlet hose with the blue
bre washer.
3. Flushing out the cartridge
Open the isolation valve. Ventilate the
system by activating the boiling water
tap (push-push-turn) and run for 20
seconds. Check for leaks. Now activate
the boiling function again and let the
water run for about 5 minutes, until the
water runs clear. Switch on the tank using
the Q button. Once the water has heated
up again, the Quooker system is ready to
use (continue to section C).
B
B
A
A