28
---------------------------
F: 1v-WE
P: QC061010
C:
QTouchPC
RAM: 8192K
SERIAL#: 1234567
---------------------------
9.2 Easy Programming
The easy programming of PLU’s is done in manager mode (M) only. To program a PLU enter the
number of the data field you want to change and confirm with the “Subtotal” key. The following data
fields are available:
1 Sales Price
2 Cost Price
3 Description
4 Description 2
5 Department Link
6 Add Stock
7 Subtract Stock
8 Minimum Stock
After selecting a data field, enter the new value, confirm it by pressing “Subtotal” again, and
choose a PLU to be programmed. This can be done either by pressing a direct PLU key or by
entering the number on the “PLU” key. If you want to continue programming articles, you may
repeat the same steps. To finish the programming mode press the key “Subtotal” without entry.
Example: Change price of PLU 5 to 2.00 EUR:
9.3 Program Version and Test Routines
The QTouch 15 have a set of test routines built-in to check
certain hardware components and receive information
about the installed drivers and software version.
Enter the test number in mode P and confirm with the key
“TYPE”. Please note the programming of the system keys.
By default the “TYPE” key is located on the key “PLU”.
The following test routines are available:
302 Display Test
305 Print out Program Version
306 Init printer
400 Transaction Test Direct Sale
401 Transaction Test Tables
Example: Print out the actual software version (only in P mode):
PLU
To Next Page
Loading...
Need help?
General
