12
Maximum Speed
Set a maximum speed limit. This speed will not be exceeded during drive time.
Maximum RPM
Set the maximum motor RPM limit. This level will not be exceeded during drive time.
Error History
M = Motor connection problem / motor malfunction / motor damage
T1 = Temperature issue in ESC
T2 = Temperature issue in motor
S = Sensor problem
V = Voltage too low
R = Receiver signal problem
10. LED Error Status
When the ESC is turned on the LED lights will flash to indicate the following statuses:
GREEN and RED LED blink simultaneously: ESC is not connected to motor or ESC lines are short-circuited. If problem
persists, the ESC’s FET is damaged. Send the product to the R1WURKS Service Center for repair.
RED LED blinks one time repeatedly: no receiver signal. Check the transmitter/receiver connection.
RED LED blinks two times repeatedly: low voltage, cutoff activated.
RED LED blinks three times repeatedly: motor sensor problem. Check the sensor cable connection and motor status.
RED LED blinks four times repeatedly: ESC temperature protection activated.
RED LED blinks five times repeatedly: PWM output is occurring but the motor is idle for more than 2 seconds.
Check the motor status or check the car.
RED LED blinks six times repeatedly: motor temperature protection activated.
RED LED blinks seven times repeatedly: BEC output problem. Check the servo.
To Next Page
Loading...
Need help?
General