R1 WURKS LCG Digital-3 2S/1S - Motor-Wiring

11
 B.E.C Voltage
Set the voltage supplied to the receiver. Refer to the servo specifications for accurate voltage values, as the ESC may
become irreparably damaged.
7.4V does not work when using a 1S battery.
 Motor Pole Num
Set the motor poles. Incorrect pole setting could result in inaccurate maximum speed readings.
 Gear Ratio
Set the vehicle gear rate. Incorrect gear ration setting could result in inaccurate maximum speed readings.
 Tire Diameter
Set the tire diameter. Incorrect tire diameter setting could result in inaccurate maximum speed readings.
 Motor-Wiring
Set the motor cable connection: A-B-C or C-B-A. Make sure the wire configuration and Motor-Wiring setting match,
as the ESC could become irreparably damaged.
 Units
You can change the unit to display temperature and speed.
 Download
Download and store to the ESC any setting values changed on the setup card.
 Factory Setting
Restore the ESC setting parameters to the original factory defaults.
 Current Voltage
View the battery voltage when the program is connected.
 Current Temp
View the ESC’s temperature when the program is connected.
 Max Temperature
View the ESC’s highest temperature achieved during drive time when the program is connected.
 Motor Temp
View the motor’s temperature when the program is connected.
 Motor Max Temp
View the motor’s highest temperature achieved during drive time when the program is connected.
 Max Current
View the highest current that achieved during drive time when the program is connected.