Need help?Do you have a question about the R1 WURKS LCG Digital-3 2S/1S and is the answer not in the manual?
General| Brand | R1 WURKS |
|---|---|
| Model | LCG Digital-3 2S/1S |
| Category | Controller |
| Language | English |
Safety and performance precautions for soldering and preventing short circuits during connection.
Correctly connect motor wires (A/B/C) and sensor wire; reverse if needed.
Connect power capacitor, noting polarity, for ESC protection and performance.
Connect battery wires paying attention to polarity to avoid ESC damage.
Connect ESC throttle wire to receiver CH2; avoid external receiver power.
Boost timing setting for speed/efficiency; affects output and RPM, causes heating.
Boost operates by throttle ratio, not RPM, affecting output based on percentage.
Allows setting timing limit with 10 steps of throttle location in Boost Mode.
Sets minimum RPM to activate Boost timing; must be lower than Boost Max RPM.
Sets maximum RPM limit for Boost timing; caps boost at specified degrees.
Delays turbo activation; turbo activates after set delay time has elapsed.
Sets time to reach turbo speeds; lower value means more acceleration and heating.
Sets time to recover from turbo speeds; lower value decreases brake effect.
Allows gentle start with boost value effect in '-' direction for strong motor output.
Sets ESC cutoff temperature; disabling is not recommended to prevent damage.
Sets motor cutoff temperature; disabling is not recommended to prevent damage.
To Next Page