To Next PageTo Next Page
Need help?Do you have a question about the Radial Engineering JDX 48 and is the answer not in the manual?
General| Channels | 1 |
|---|---|
| Input Impedance | 1 MΩ |
| Ground Lift | Yes |
| Polarity Switch | Yes |
| Frequency Response | 20 Hz - 20 kHz |
| Signal to Noise Ratio | >100 dB |
| Weight | 1.5 lbs |
| Input | 1/4" (6.35 mm) TRS |
| Outputs | XLR, 1/4" Thru |
| Output Impedance | 600 Ω |
| Enclosure | Steel |
Emphasizes that the JDX 48 is not a load box and requires a loudspeaker or load box for amplifier safety.
Mandates turning the amplifier off before connecting or disconnecting the JDX 48 to prevent damage.
Strictly prohibits using the JDX 48 with amplifiers having bridged or balanced speaker outputs due to shock risk.
Explains how the JDX 48 differs from standard DIs by tapping amplifier output for a unique sound.
Details using the JDX 48 to replace a microphone for capturing amp sound, eliminating variables.
Describes combining the JDX 48 signal with a microphone for richer guitar tones and effects.
Explains how to use the JDX 48 with the Radial Phazer for time-aligning signals for fat sounds.
Explains the FROM AMP input and TO SPEAKER thru-put for patching the JDX 48 between amp and speaker.
Details the Transformer, Active Bandpass Filter, and Active Balanced Driver stages in the signal path.
Describes the Ground Lift and 180° Polarity Reverse switches for noise reduction and phase alignment.
Details combining the JDX 48 signal with a microphone for richer textures and stereo effects.
Lists technical specifications including audio circuit type, frequency response, input/output levels, and dimensions.
