Need help?Do you have a question about the Radial Engineering Tonebone Headbone VT and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| Tube | 12AX7 |
| Input Impedance | 1M Ohm |
| Footswitch I/O | 1 x 1/4" (Footswitch) |
| Inputs | 1 x 1/4" (Instrument) |
| Construction | 14 gauge steel |
| Power Supply | 15V DC power supply (included) |
Details user responsibility for product suitability and safe operation, including grounding and electrical safety.
Emphasizes turning off amplifiers and setting volumes to zero before connecting.
Provides recommendations for using quality shielded guitar and unshielded speaker cables.
Guides the initial connection of the guitar to the unit's buffered input.
Details the correct connections for both amplifier heads and the speaker cabinet.
Instructs on connecting power and testing the system functionality at low volume.
Warns against placing delay effects after the Headbone due to potential operational issues.
Stresses matching amplifier and speaker impedance for optimal performance and longevity.
Emphasizes using 3-prong grounded amplifiers for electrical safety and shock prevention.
Describes the safety feature that ensures an amp always sees a load when power is disconnected.
Advises on correct placement of delay and looping effects in the signal chain.
Strongly warns against using non-specified power supplies with the Headbone.
To Next Page
