Need help?Do you have a question about the Radial Engineering Trim Two and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| Outputs | 2 x XLR |
| Total Harmonic Distortion | < 0.01% |
| Frequency Response | 20Hz - 20kHz |
| Ground Lift | Yes |
| Inputs | 2 x 1/4" TRS |
| Control | Ground lift |
| Output Impedance | 150 Ohms |
| Noise | -100 dBu |
| Gain | 0dB |
| Power Supply | Passive, no power required |
| Construction | 14-gauge steel |
| Dimensions | 3.3" x 5" x 2" (8.4cm x 12.7cm x 5cm) |
Describes the 1/4", RCA, and 3.5mm TRS stereo inputs for connecting various audio sources.
Details the LEVEL control for input adjustment and the MONO SUM switch for stereo to mono conversion.
Explains the balanced XLR outputs and the GROUND LIFT switch for noise elimination.
Covers BOOKEND DESIGN, NO SLIP PAD, and 14-GAUGE STEEL construction for protection and stability.
Explains how to set the volume control to 2 o'clock as a starting point for optimal output.
Details how the GROUND LIFT switch eliminates hum and buzz caused by ground loops.
Describes using the recessed MONO SUM switch to combine stereo signals to mono for PA systems.
Connects laptop/tablet via 3.5mm stereo cable to Trim-Two, then XLRs to PA system.
Connects CD player RCA out to Trim-Two for distribution to ceiling/outdoor speakers.
Connects keyboard via 1/4" cables to Trim-Two and PA, RCA to 1/4" for monitors.
Connects laptop 3.5mm to Trim-Two, XLR to PA, 1/4" to monitors, using laptop for audio files.
Connects DJ mixer to Trim-Two using RCA or 1/4" inputs to set maximum level and control output.
Details rack chassis with vertical (J-Rak 8) and horizontal (J-Rak 4) slots for direct box mounting.
Describes the J-Clamp adapter for permanent mounting of J-Class products in podiums or racks.
To Next Page