Radijator Inženjering d.o.o, 36000 Kraljevo, Živojina Lazića - Solunca br.6, Srbija
tel. +381 36 399 140, fax. +381 36 399 150, http://www.radijator.rs
e-mail: radijator@radijator.rs
32
2. Assembly
Solid fuel heating boiler is delivered with outer lining containing the insulation 30 mm thick.
The unit is equipped with the fan and automation system and both devices
use the power supply of 230V, so that improper assembly and incautious maintenance
can endanger human life by means of electric current shock.
Solid fuel heating boiler, even with forced drought, should be assembled
according the valid norms and legal regulations. Any change either in mechanical
construction or electric system shall be understood as the violation of the guarantee
conditions and will lead to its violation.
In an assembly the boiler should be properly protected against the excessive
overpressure and overheating.
For the proper installation the plumber/installer is responsible.
The manufacturer (Radijator inzenjering) does not take any responsibility
coming from the incorrect installation of the boiler.
Basic requirements that should be delivered during assembly are:
- the unit must be connected onto the open heating system
- the unit must be located at a safe distance from easy inflammable materials
- Electric power supply of the unit is 230V and 50 Hz and the connection of all items
belonging to the unit should be performed according to the valid regulations, and the
connecting itself is done by the authorized person.
Connection to the chimney is also performed according to the bounding regulations as well as
to the recommendations of the manufacturer which is clear in the text to come.
3.1 Measures and safety devices for boilers
For safe operation of boiler it is necessary to assemble and maintain the following elements
in working condition:
- Pressure Safety valve (Figure 1)
Figure 1 Figure 2
To Next Page
Loading...
