9
Basic Operation
Set Radio Station Memory
1. Press AM or FM to toggle between AM1, AM2,
FM1 or FM2. The selected band indicator
appears on the left side of the display.
2. Press or to find a station.
3. Briefly hold a memory button (M1–M5) until the selected memory indicator
(M1–M5) appears on the right side of the display.
You can store up to five channels each for
AM1, AM2, FM1, and FM2.
4. To listen to a preset station, press
AM or FM to toggle between AM1,
AM2, FM1 or FM2, then press one of memory buttons M1–M5.
Using the Weather Radio
Press WX to listen to the weather radio. The radio will select the last channel
used.
Manual Scan – Press WX, then press or .
Auto Scan – Press WX and then briefly hold
or until the channels start to change. The
radio stops when it finds the channel with strongest
signal strength.
n Notes:
•
All seven NOAA weather channels are preprogrammed on your radio. If the
radio cannot find a signal, it will keep scanning.
• If the weather signal is lost, WARNING and ADVISORY alert indicators
flash alternately, and WATCH indicator lights.
• If you are having trouble finding a weather signal, try adjusting the antenna
or moving the radio to a different location. You may need to install an
external antenna. See “External Antenna” on page 7.
• If the radio has not received a SAME alert signal (including test or demo
signals) for 10 days or longer, a warning message will scroll on the display:
“10 days have lapsed since last message received. Check
reception.” See “How do I test my radio?” on page 20.
To Next Page
Loading...
Need help?
General
