Setting the Clock
3
5'66+0)"6*'"%.1%-
You can use Time 1 and Time 2 to keep track of the time in
two different time zones.
1. Turn off the radio, then press
TIME 1/2
to select Time 1
or Time 2.
'ý
'ý'ý
'ý
or
(
((
(
appears.
2. Press
MEM/TIME
. The display flashes.
3. Within 5 seconds, repeatedly press or hold down
HOUR
to set the hour.
4. Repeatedly press or hold down
MIN
to set the minute.
±
5. To view both time zones while the radio is on, hold
down
TIME 1/2
for 3 seconds. The time zone last
displayed appears.
6. Press
TIME 1/2
again to view the other time zone.
75+0)"'#42*10'5"14"
*'#&2*10'5
You can use the built-in speaker, or stereo earphones or
headphones (not supplied, available from RadioShack) with
a
1
/
8
-inch plug to listen privately to the radio.
To listen to the radio using earphones or headphones, insert
the earphones/headphones’ plug into the radio’s
V
jack.
This disconnects the built-in speaker.
.+56'0+0)"5#('.;
To protect your hearing, following these guidelines when
you use earphones or headphones.
• Set the volume to the lowest setting before you begin
listening. After you begin listening, adjust the volume to
a comfortable level.
• Do not listen at extremely high volume levels. Extended
high volume listening can lead to permanent hearing
loss.
• Once you set the volume, do not increase it. Over time,
your ears adapt to the volume level, so a volume level
that does not cause discomfort might still damage your
hearing.
±
"016'"
±
"
•
FC
FCFC
FC appears at a PM hour. 7C
7C7C
7C
appears at an AM hour.
• When you change the minute
setting for one time zone, it
automatically changes for both.
12-898.fm Page 3 Tuesday, March 26, 2002 12:12 PM
To Next Page
Loading...
Need help?
General
