Remote Control
16 Turn On Power Key Priority-Press
TURN ON POWER KEY PRIORITY-PRESS
The Power key class is the POWER key. To setup Power class key perform the following
steps:
Power Key Priority-Press Setup
1. Press a device key (TV, VCR, CBL/SAT or DVD). The red light
blinks one time.
2. Press P key. The red light blinks two times.
3. Press Power Key. The red light blinks three times.
When the POWER key is pressed, power on/off will only work for the selected device.
CHANNEL KEY PRIORITY-PRESS
The Channel class keys are CH+, CH- Last and the digit keys. To setup and turn on
channel class key to various devices perform the following steps:
Channel Key Priority-Press Setup – TV
1. Press TV key. The red light blinks one time.
2. Press P key. The red light blinks two times.
3. Press number CH+, CH- or Last key. The red light blinks three
times.
When the CH+, CH-, Last or digit keys are pressed the remote will only change channels
through TV.
Channel Key Priority-Press Setup – CBL/SAT
1. Press CBL/SAT key. The red light blinks one time.
2. Press P key. The red light blinks two times.
3. Press number CH+, CH- or Last key. The red light blinks three
times.
When the CH+, CH-, Last or digit keys are pressed the remote will only change channels
through the CBL/SAT box.
Channel Key Priority-Press Setup – VCR
1. Press VCR key. The red light blinks one time.
2. Press P key. The red light blinks two times.
3. Press number CH+, CH- or Last key. The red light blinks three
times.
When the CH+, CH-, Last or digit keys are pressed the remote will only change channels
through the VCR.
Note: Digit keys cannot be used to program the channel class. To remove Channel Key
Priority-Press repeat the set up steps for the appropriate device.
To Next Page
Loading...
