Remote Control
Volume Key Priority-Press 17
VOLUME KEY PRIORITY-PRESS
The Volume class keys are VOL+, VOL- and MUTE. To set up volume class key perform
the following steps:
Volume Key Priority-Press Setup – TV
1. Press TV key. The red light blinks one time.
2. Press P key. The red light blinks two times.
3. Press VOL+, VOL- or MUTE key. The red light blinks three times.
When the VOL+, VOL- or MUTE keys are pressed, the volume will only be controlled through
the TV.
Volume Key Priority-Press Setup – CBL/SAT
1. Press CBL/SAT key. The red light blinks one time.
2. Press P key. The red light blinks two times.
3. Press VOL+, VOL- or MUTE key. The red light blinks three times.
When the VOL+, VOL- or MUTE keys are pressed, the volume will only be controlled through
the CBL/SAT box.
Volume Key Priority-Press Setup – VCR
1. Press VCR key. The red light blinks one time.
2. Press P key. The red light blinks two times.
3. Press VOL+, VOL- or MUTE key. The red light blinks three times.
When the VOL+, VOL- or MUTE keys are pressed, the volume will only be controlled through
the VCR.
Volume Key Priority-Press Setup – DVD
1. Press DVD key. The red light blinks one time.
2. Press P key. The red light blinks two times.
3. Press VOL+, VOL- or MUTE key. The red light blinks three times.
When the VOL+, VOL- or MUTE keys are pressed, the volume will only be controlled through
the DVD.
To remove Volume Key Priority-Press repeat the setup steps for the appropriate device. Two
blinks of the red light indicate Volume Lock is turned off.
TRANSPORT KEYS PRIORITY-PRESS
The Transport class keys are REW, PLAY, FFWD, REC, STOP, and PAUSE. To setup
and turn on transport class keys to devices perform the following steps:
Transport Key Priority-Press Setup
1. Press VCR or DVD key. The red light blinks one time.
2. Press P key. The red light blinks two times.
3. Press a Transport Class Key. The red light blinks three times.
When a Transport Class key is pressed, transport keys will only work for the selected device.
To Next Page
Loading...
