17
Using the Meter
To turn the meter back on after it automatically
turns off,
press any button.
75+0)"219'4".1%-
To set the meter so it does not turn off
automatically, set the function selector to
OFF to
turn it off. Hold down
HOLD and SELECT at the
same time, then turn on the meter.
FBeY
FBeYFBeY
FBeY appears
until you release
HOLD and SELECT. The meter sets
itself to its normal test mode and does not
automatically turn itself off.
±
To reset the meter so it automatically turns itself off,
turn off the meter then turn it back on. The meter
automatically turns itself off after about 30 minutes.
75+0)"/10+614
You can use the meter to monitor maximum and
minimum readings in a circuit, saving both readings
for you to check.
As the meter monitors, it displays the minimum or
maximum value it measured and stores those
values. If the meter measures a value higher than
the stored maximum value or lower than the stored
minimum value, it updates the value it stored with
the new value. The meter automatically sets itself to
manual mode when you use it to monitor.
1. Set the meter to any function except
°
°°
°
C/
°
°°
°
F
,
dBm
,
–
––
–
,
„
„„
„
, LOGIC, or
h
FE
.
2. Connect the test leads to the circuit you want to
measure. To measure different circuits, see
“Making Measurements” on Page 18.
3. Press
RANGE. disappears. Then
repeatedly press
RANGE until the range you
want appears.
4. Press
MAX/MIN until CWn
CWnCWn
CWn appears on the left
side of the display (to set the meter to record
the maximum and minimum values). Then
±
"016'"
±
"
The meter automatically
sets itself to its power lock
mode while you use it to
monitor (see “Using
Monitor”).
AUTO
22-812.fm Page 17 Monday, April 8, 2002 1:32 PM
To Next Page
Loading...
