Radio Shack 4-CHANNEL STEREO SSM-1750

Questions and Answers:

V
Victoria GreenJul 30, 2025
How to troubleshoot a Radio Shack 4-CHANNEL STEREO SSM-1750 Music Mixer that does not work?
- A
  angela68Jul 31, 2025
  If your Radio Shack Music Mixer isn't working, first verify the AC power cord is securely connected and the outlet is active. Then, check the power connections to the rest of your audio system, including the amplifier/receiver and input sources. If it still doesn't work, inspect the fuse. Refer to “Replacing the Fuse” on Page 14 of the manual for instructions.
M
Maria SmithAug 5, 2025
What to do if Radio Shack 4-CHANNEL STEREO SSM-1750 Music Mixer has feedback noise?
- M
  Mr. Joseph SmithAug 5, 2025
  If you're experiencing feedback noise with your Radio Shack Music Mixer, try moving the microphone further from the output speakers. Alternatively, consider using a unidirectional microphone to minimize the feedback.
T
Teresa FrancoAug 11, 2025
Why Radio Shack 4-CHANNEL STEREO SSM-1750 Music Mixer has hum from PHONO sources?
- K
  Kari MooreAug 11, 2025
  If you're getting a hum from the PHONO sources on your Radio Shack Music Mixer, ensure the turntable’s ground wire (usually black or green) is securely connected to the GND screw located on the back of the mixer.
T
Tiffany SmithAug 16, 2025
What to do if Radio Shack Music Mixer has no signal from an audio input sources?
- T
  Tristan JonesAug 17, 2025
  If you're not getting any signal from an audio input source on your Radio Shack Music Mixer, first ensure that the TALKOVER switch is set to OFF. Next, check both the mixer's and the source's control settings to make sure they are properly adjusted. Finally, verify the connection between the mixer and the input source is secure.
W
wilsonemilyAug 22, 2025
Why Radio Shack 4-CHANNEL STEREO SSM-1750 Music Mixer has hum from other input source?
- P
  Patricia BrooksAug 23, 2025
  If you're experiencing a hum from other input sources on your Radio Shack Music Mixer, ensure that no low-level inputs are connected to the LINE input jacks.