Radio Shack 4 Quick Reference

REMOVE device
[device] ...
Removes devices
from the
device table.
REMOVE *LU
RENAME filel
[TO] file2
RENAME device 1 [TO] device2
Changes the name of a
file or
device.
RENAME
TEXT/DAT :0
TO OLD/DAT
RENAME
*UD TO
*TX
REPAIR :drive
Updates
system information
on disks
which were
formatted under
Model I TRSDOS.
REPAIR :1
RESET device
RESET me
Returns
a
device to
its original start-up
condition.
Closes
an open file.
RESET *PR
RESET
PRINTER/DAT
ROUTE
device 1
[TO] device2
ROUTE device [TO] file
[(REWIND)]
ROUTE device
(NIL)
Routes a
device to
another device, to a
disk file, or to
nothing (NIL).
ROUTE *PR
*D0
ROUTE #PR TO
PRINTER/DAT
[RUN] [(X)] file [(command
text)]
Loads and executes a
program, command
text is
optional values
the program may require.
RUN CONTROL/CMD
CONTROL/CMD
SET device
[TO] driver file [(parameters)]
Assigns
a
driver program to a
device, parameters
are
optional values the
driver program may
require.
SET
*SP TO SERIAL/DRV
SET phantom device [TO]
filter file [USING]
[parameters]
Assigns a filter program to a
phantom device.
parameters
are optional values the
filter program may
require.
SET #LC TO TRAP/FLT
SETCOM
[(DEFAULT,
BAUD
-
number, WORD
-
number, STOP
=
number,
PARITY
-
switch, QUERY,
BREAK=value.EVEN.ODD)]
Sets up
RS-232C communications or
display
status.
SETCOM <BAUD=300
,W0RD=8
,STOP=i
.
PARITY=OFF)

Radio Shack 4 Specifications

General

Brand	Radio Shack
Model	4
Category	Remote Control
Number of Devices	4
Type	Universal Remote