16
Telephone Operation
few seconds. MUTE appears at the bottom of the
screen until the mute function is turned off.
2. Press MUTE/REMOVE again to resume the
conversation. The handset screen temporarily
shows MICROPHONE ON.
Ringer Mute
When the telephone is ringing, press OFF/CLEAR
or MUTE/REMOVE to temporarily silence the ringer
without disconnecting the call. The next call rings
normally.
Call Waiting
If you subscribe to call waiting service from your telephone company, you
hear an alert tone if there is an incoming call while you are on another call.
Press /FLASH to answer the new incoming call. Press /FLASH again
to return to the original call.
Find Handset
Use this feature to page all system handsets.
Press FIND HANDSET on the telephone base.
All idle handsets ring and the screens show
** PAGING **.
To end paging, press /FLASH, , any
dialing keys (0-9, #, *), or press
FIND HANDSET on the telephone base.
Chain Dialing
Use this feature while already dialing one phone number or while on a call
to initiate a dialing sequence from numbers stored in the directory, stored in
the call log, or from the most recent redial phone number. Chain dialing can
be useful when accessing numbers other than phone numbers (such as bank
account information or access codes).
To access a number in the directory while on a call:
1. Press MENU/SELECT twice to select >DIRECTORY.
2. Scroll to the desired entry by pressing or .
3. Press MENU/SELECT to dial the displayed number.
PHONE 0:00:00
MUTED
MUTE
RINGER MUTE
To Next Page
Loading...
