6
Telephone Setup
Battery Installation and Charging
Install the battery as shown below. For best performance, charge the
handset for at least 16 hours before use. When not in use, place the handset
in the telephone base or charger. See page 32 for battery operating times.
1. If the battery compartment cover is on the handset, press the
indentation and slide the cover to remove.
2. Plug the battery securely into the plug inside the handset battery
compartment, matching the color-coded label.
3. Place the battery with the label THIS SIDE UP facing up and the wires
inside the battery compartment.
4. Align the cover flat against the battery
compartment, then slide it towards the center
of the handset until it clicks into place.
5. Charge the handset by placing it in the
telephone base or charger. The CHARGE
light is on when the handset charges.
Match with color-coded label
Red wire
Black wire
To Next Page
Loading...
