Window
displays
Descriptions
1-99 (flashing) Current message number during new message playback.
1-99
Current message number during old message playback.
1-8 T Telephone base speaker volume level while adjusting.
-- Telephone is answering a call or being accessed
remotely. The answering system is being programmed.
-- (flashing) Telephone is being initialized.
0-6 Telephone base ringer level while adjusting.
n Note: If the memory is full, the answering system answers incoming
calls after 10 rings and announces, “Memory is full. Enter the remote access
code.”
Remote Access
A two-digit security code is required to access the answering system
remotely from any touch tone telephone. The preset code is 19; see “Remote
Code” on page 15 to change it.
1. Dial your telephone number from any touch tone telephone.
2. When the system plays your announcement, enter the two-digit security
code.
3. You can also enter one of the following remote commands.
Command Function
1 Play all messages.
2 Play only new messages.
3 Delete the current message (during playback).
33 Delete all messages.
4 Repeat the current message (during playback).
5 Stop.
*5 Hear a list of remote commands.
6 Skip to the next message (during playback).
*7 Record a new announcement.
To Next Page
Loading...
