16
Preparation
To ensure maximum range, operate the
transceiver with the battery pack fully
charged. As the voltage decreases, the
range decreases.
Caution:
The supplied 12V DC, 200 mA
battery charger was designed specifically
for your transceiver. Use only the sup-
plied battery charger.
1. Turn
VOLUME/OFF
fully counter-
clockwise until it clicks to turn off the
transceiver.
2. Pull out the rubber cover on the
DC
12V
jack on the lower side of the
transceiver and insert the charger’s
barrel plug into the jack. Then plug
the other end of the charger into a
standard AC outlet.
If TX/BATT lights red and flashes
green when the transceiver is on, the
transceiver has about 60 minutes of
19-1207.fm Page 16 Friday, November 10, 2000 11:04 AM
To Next Page
Loading...
Need help?
General
