RS-80 MODEL Hi DISK SYSTEM
This
command lets you
provide
a command to be executed whenever trsdos
is
started
(power-up or reset).
You
can use it to get a desired program
running
without any
operator action required, except for typing in the
date and time.
When you
enter an auto
command, trsdos writes
command-line into
its
start-
up
procedure,
trsdos does not check for
valid
commands; if the command
line
contains an
error, it will be detected
the
next time the System is started
up.
Examples
AUTO DIR
(SYS)
Tells trsdos to
execute the command dir (sys) after the
start-up procedure.
Each time the
System is reset
or powered
up, it will automatically execute
that
command after you
enter the date and time.
AUTO
BASIC
Tells trsdos
to load and
execute basic each
time the System is started
up.
AUTO FORMS
(WIDTH=80)
Tells trsdos to
reset the printer
width parameter
each time the System is started
up.
AUTO
PAYROLL/ CMD
Tells trsdos to
load and execute payroll/cmd (must
be a
machine-language
program) after each
System start-up.
AUTO DO STARTER
Tells trsdos to
take automatic key-ins
from the file named starter after
each
System start-up. See
build and do.
To Erase an AUTO
Command
Type:
AUTO (ENTER)
This tells trsdos to
erase any automatic command. The command will
be
deleted the next time you
power-up or reset the
System.
The
acknowledgement:
AUTO
=
"
" is displayed after
an erasure.
To
Override an
AUTO Command
You
can bypass
any automatic command
by
holding
down (ENTER) while pressing
reset. You must
continue holding down (ENTER)
until you are prompted for the
date during the
initialization process.
30
To Next Page
Loading...
Need help?
General
