Radio Shack CCR-81 Operation Manual

Computer Graphics Operation Manual
----------TRS-BO <B> _
Printing Graphics Displays
There are many ways to use the stand-alone utilities
(described in Graphic utilities). The following discussion
demonstrates one way to use the utilities with graphic
displays generated under BASICG.
To print graphics, follow these steps:
1. When TRSDOS Ready appears, set FORMS to FORMS (WIDTH=255,
LINES=6~). (See your Model III Disk System Owner's
Manual. )
2. Set the printer into Graphic Mode, if possible, and set
the printer's other parameters (elongation, non-elongated,
etc.), if applicable, according to instructions in your
printer owner's manual.
3. Write, run and save your program as a BASICG program file.
4. Save the graphics memory to diskette using GSAVE.
5. Load the file into memory using GLOAD.
6. Enter the print command GPRINT.
Example
1. Set FORMS with your printer's printing parameters.
----------ItCHIIOIIIaeIi ---------
-133-

Radio Shack CCR-81 Specifications

General

Brand	Radio Shack
Model	CCR-81
Category	Desktop
Language	English