To save the frequency into the current monitor memory, press MON.
To continue searching, press /\ or \/.
To stop searching and listen to the frequency, press 91-100/0.
-H- (hold) appears on the display.
To continue automatic searching after you stop a search, either press
91-100/0 or press and hold down /\ or \/ for about 1 second.
Notes: You can change the direction of either an automatic or manual
search by pressing /\ or \/ once.
If you manually tune to a search skip frequency, the display shows
L/O (see "Skipping Frequencies/Channels" in Faxback Doc. # 46802).
Direct Search
You can enter a frequency, then search for transmissions above or below
that frequency within the frequency bands.
Note: You can use the scanner's delay feature while using direct search.
See "Delay" in Faxback Doc. # 46802.
1. Press MANUAL.
2. Use the number keys to enter the frequency you want to start the
search from. Press CLEAR/. to enter a decimal point.
3. Press /\ or \/ to search up or down from the selected frequency.
-d- (direct), SRCH, and /\ or \/ appear on the display, and the next
available monitor memory number flashes.
Note: If you enter an invalid frequency in Step 2 and the scanner
displays Error, press CLEAR/. then repeat Steps 2 and 3.
4. When the scanner finds an active frequency, you can do any of the
following:
To save the frequency into the current monitor memory, press MON.
To continue searching or change the search direction, press /\ or \/.
To stop searching and listen to the frequency, press 91-100/0.
-h- (hold) appears on the display.
To continue searching after you stop a search, either press 91-100/0 or
press /\ or \/ for about 1 second.
Note: If you manually tune to a search skip frequency or 000.0000, the
display shows L/O (see "Skipping Frequencies/Channels" in Faxback
Doc. # 46802).
Searching Service Search Banks
1. To search one or more service search banks, press any of these buttons:
POLICE FIRE-EMG
DOT
To Next Page
Loading...
