24
• To hold the frequency, press
HOLD/BAND.
h
appears on the dis-
play. To continue the search, press and hold t or s for about 1
second.
Notes:
• If you want to step through the frequencies while
h
is displayed,
press t or s.
• If you tune to a search skip frequency,
L
appears on the dis-
play (see “Search Skip Memory”).
• If you press
HOLD/BAND
, the scanner restarts as a band
search.
b
,
SRCH
, and t or s
appear on the display.
Search Skip Memory
You can skip up to 20 specified frequencies during a band or direct
search. This lets you avoid unwanted frequencies or ones you have al-
ready stored in a channel.
To skip a frequency, press
L-OUT/S/S
when the scanner stops on the fre-
quency during a band or direct search. The scanner stores the frequen-
cy in memory and resumes the search.
To clear a single frequency from skip memory so the scanner can stop
on it during a band or direct search, press
HOLD/BAND
to hold the
search, press t or s to select the frequency, then press
L-OUT/S/S
until
L
disappears from the display.
To clear all the skip frequencies at once, while in the search mode,
press
HOLD/BAND
, then press and hold
L-OUT/S/S
until the scanner
beeps twice (about 3 seconds).
Notes:
• If you program more than 20 frequencies to skip, each new fre-
quency replaces ones you stored earlier, starting from the first
stored frequency.
• You can select the skipped frequency when the scanner is in the
hold mode. The scanner displays
L
when you select a skipped fre-
quency.
20-508.fm Page 24 Wednesday, August 4, 1999 1:50 PM
To Next Page
Loading...
