23
3. To change the search direction, press t to search downward or s to
search upward.
b
,
SRCH
, and t or s appear on the display.
4. When the scanner stops on an active frequency, you can do one of
the following:
• To store the displayed frequency into the monitor memory,
press
MON/0
.
MON
appears on the display.
• To continue the search, press t or s.
• To hold the frequency, press
HOLD/BAND
.
H
appears on the
display. To continue the search, press and hold t or s for about 1
second.
H
disappears from the display. The scanner briefly dis-
plays the frequency band, then resumes scanning where you
stopped.
Notes:
• If you want to step through the frequencies while
H
is displayed,
press t or s.
• If you tune to a search skip frequency,
L
appears on the display.
See “Search Skip Memory.”
• If you want to change the frequency band, repeatedly press
HOLD/BAND
. The selected frequency band is displayed.
Direct Search
You can search up or down for more frequencies from the currently dis-
played frequency.
1. Press
MANUAL
.
2. Use the number keys and
CLEAR/.
to enter the frequency (includ-
ing the decimal point) you want to start the search from, or enter
the channel number containing the starting frequency.
3. Press t to search downward or s to search upward from the
selected frequency.
d
,
SRCH
, and t or s
appear on the display.
4. When the scanner stops on a transmission, you can do one of the
following:
• To store the displayed frequency into the monitor memory,
press
MON/0.
MON
appears on the display.
• To continue the search, press t or s.
20-508.fm Page 23 Wednesday, August 4, 1999 1:50 PM
To Next Page
Loading...
